Home › Recent Projects & Typical Costs

Recent Projects & Typical Costs

The question every homeowner asks first is what a job like theirs costs. The write-ups below are project records for Thompson Valley homes. They show the work we do, job by job. Each one lists the old equipment, the new equipment, the scope of work, and typical pricing. Some details are generalized for customer privacy. Your home will differ some. The only exact number is a written estimate on your own system. To get one, free, call (970) 427-9822.

Loveland-area home under snow during heating season
Loveland-area home under snow during heating season.

96% Furnace Replacement in a 1970s Ranch Near Lake Loveland

$7,400

Completed
September 2026
Customer
Steve and Judy — Loveland, CO
Location
Loveland, CO
Project
Furnace replacement
System
96% AFUE two-stage condensing gas furnace, 80,000 BTU, variable-speed ECM blower
Home size
1,650 sq ft
Existing condition
1998 80% AFUE furnace, 28 years old. The heat exchanger was cracked. We found it on a no-heat call. It was a carbon monoxide risk, so the unit was shut down for safety.
Approx. project cost
$7,400
Scope of work
Removed and hauled away the old furnace. Set the new condensing furnace. Ran new PVC venting and a condensate drain with pump. Replaced the thermostat. Pulled the city permit. Ran a full startup test with a combustion check at Loveland altitude settings.

Steve and Judy called on a cold morning with no heat. The inspection found the failure nobody wants: a cracked heat exchanger. The furnace was old enough that parts were scarce. Replacement beat repair on every measure. The new 96% unit cut the home's gas use per winter. It also ended the cold spots in the back bedrooms. The job took one day. The house was warm again by dinner.

Technician inspecting an outdoor air conditioning unit
Technician inspecting an outdoor air conditioning unit.

AC and Coil Replacement in a Centerra Two-Story

$8,950

Completed
June 2026
Customer
Marcus — Loveland, CO
Location
Loveland, CO
Project
Air conditioner and evaporator coil replacement
System
3-ton central AC, 16 SEER2, with matched indoor evaporator coil
Home size
2,400 sq ft
Existing condition
2011 2.5-ton 13 SEER unit, 15 years old. It had a slow refrigerant leak at the coil. It was undersized for the home. Upstairs rooms ran 5 to 6 degrees hot every summer.
Approx. project cost
$8,950
Scope of work
Ran a load calculation on the home. Removed the old condenser and coil. Set the new 3-ton condenser on a new pad. Installed the matched coil. Flushed and charged new refrigerant lines. Reprogrammed the thermostat. Handled the permit and city inspection.

This east Loveland home had the classic two-story problem. The downstairs stayed fine while the upstairs bedrooms cooked. The old unit was both leaking and a half-ton small for the house. The new unit is the right size, with a matched coil. It evened out the upstairs temperatures in the first week. The electric bill for July came in lower than the year before, despite the bigger unit.

Technician servicing an outdoor unit with manifold gauges
Technician servicing an outdoor unit with manifold gauges.

Cold-Climate Heat Pump Conversion in Mariana Butte

$13,900

Completed
January 2026
Customer
Sarah — Loveland, CO
Location
Loveland, CO
Project
Heat pump conversion (dual-fuel)
System
3-ton cold-climate heat pump, 18 SEER2 cooling / 9.5 HSPF2 heating, paired with the home's existing gas furnace as backup heat
Home size
2,150 sq ft
Existing condition
2009 central AC with a failed compressor. The gas furnace was from 2019 and in good shape. Sarah wanted lower cooling costs and one system for shoulder seasons.
Approx. project cost
$13,900
Scope of work
Removed the dead AC condenser and coil. Installed the heat pump and matched coil. Wired the dual-fuel controls, so the furnace takes over below the balance point. Added a new smart thermostat. Verified the refrigerant charge. Handled the permit and inspection.

A sound 2019 furnace was already in the basement. A full rip-out made no sense. The heat pump now handles cooling and all heating down to the mid-20s. The gas furnace carries the coldest nights. Sarah gets efficient electric heat for most of the Thompson Valley's mild winter days. She gets gas heat when the Big Thompson canyon winds push temperatures down hard.

Worker inspecting a floor register during a duct evaluation
Worker inspecting a floor register during a duct evaluation.

Full Duct Replacement in a 1960s Home Near Downtown

$6,800

Completed
August 2025
Customer
Robert and Jean — Loveland, CO
Location
Loveland, CO
Project
Complete ductwork replacement
System
New sheet-metal trunk line with R-8 insulated flex branch runs, sized from a Manual D duct design; sealed with mastic at every joint
Home size
1,480 sq ft
Existing condition
Original 1962 ductwork. The joints were wrapped in asbestos. Two runs in the crawlspace were disconnected. Some sections were rusted. The furnace was from 2020 and was fine, but two bedrooms barely got air.
Approx. project cost
$6,800
Scope of work
A licensed abatement crew removed the asbestos-wrapped sections. We pulled the old ductwork from the crawlspace. We installed and sealed new trunk and branch runs. We rebalanced the registers. We measured airflow room by room at completion.

Another company had quoted Robert and Jean a bigger furnace. Then we looked in the crawlspace. Their furnace was fine; the air just never arrived. Two runs had fallen apart, and the rest leaked into the crawlspace. New sealed ductwork put full airflow into the back bedrooms for the first time in years. It cost half the price of the oversized furnace they almost bought.

Family relaxing at home in the evening
Family relaxing at home in the evening.

Three-Zone Ductless Mini-Splits on a Berthoud Acreage

$11,200

Completed
April 2024
Customer
David and Amy — Berthoud, CO
Location
Berthoud, CO
Project
Ductless mini-split installation
System
36,000 BTU multi-zone heat pump, 20 SEER2, three wall-mounted indoor heads (living room, primary bedroom, home office)
Home size
1,900 sq ft
Existing condition
1985 home on acreage with electric baseboard heat and two window AC units. There was no ductwork anywhere in the house. Winter electric bills were high.
Approx. project cost
$11,200
Scope of work
Set the outdoor unit on a ground pad. Mounted three indoor heads. Ran line sets and condensate drains. Added a dedicated electrical circuit. Set up the remotes and walked David and Amy through the zoning controls.

Adding ductwork to this home would have meant tearing into ceilings across the whole house. Three ductless heads gave David and Amy zoned heating and cooling in the rooms they live in. The running cost is a fraction of the electric baseboards. The office head keeps one room comfortable on workdays, without conditioning the whole house.

Craftsman-style home in a Loveland-area neighborhood
Craftsman-style home in a Loveland-area neighborhood.

Swamp Cooler to Refrigerated AC Conversion in Downtown Loveland

$9,600

Completed
November 2023
Customer
Grace — Loveland, CO
Location
Loveland, CO
Project
Evaporative cooler removal and central AC conversion
System
3.5-ton central AC, 15.2 SEER2, with matched evaporator coil, tied into the home's existing gas furnace and ductwork
Home size
1,720 sq ft
Existing condition
1948 home. The roof-mounted evaporative cooler was from the 1990s, with a corroded pan and a failing pump. The furnace was from 2016 and in good condition. The ductwork tested sound.
Approx. project cost
$9,600
Scope of work
Removed the rooftop cooler and patched the roof opening. Reinforced the return-air path for refrigerated air volumes. Set the condenser and coil. Added a new electrical disconnect and refrigerant lines. Did a full charge and airflow balance. Handled the permit.

The old cooler did fine in June. It gave up every monsoon stretch, right when the house felt worst. The furnace and ducts were sound, so the conversion cost far less than a full system. The home now holds a steady temperature in any weather. The roof is clear of a rusting box. The seasonal startup and winterization routine is gone for good.

Ready to talk about your project? Call (970) 427-9822 or send a request through the contact page. Estimates on replacement work are free, and the price is flat and in writing before anything starts. The full menu of work is on the services page.

Need Heating or Cooling Help in Loveland?

Call (970) 427-9822 or send the form — estimates on replacement equipment are free, and the price is flat and in writing before work starts.

No heat or no cool? Call us. If we miss you, leave a message and we will call you back.

Get a Free Estimate

Call Now (970) 427-9822Free Estimate