Mini-splits are heat pumps at heart, so one system handles July and January. But the model matters here. We are at just under 5,000 feet. Cold air pools in the Thompson Valley on still winter nights. So we spec cold-climate units rated to keep heating in subzero weather. We do not use mild-climate equipment that gives up around freezing. Each indoor unit also runs its own temperature. That means you stop paying to heat and cool rooms nobody is using.
Call (970) 427-9822 for a free mini-split estimate.
A single-zone job runs $4,500 to $7,500. A multi-zone job runs $9,000 to $18,000. Estimates are free. One outdoor unit can feed two to five indoor heads. Each head holds its own temperature. Our mark is the spec. We fit cold-climate units that keep heating in subzero cold, not mild-climate gear that quits near freezing.
Project example: three zones on Berthoud acreage
Recent project. A 1,900 square foot home on Berthoud acreage had no ducts at all. It heated with baseboards and cooled with two window units. We set a 36,000 BTU outdoor unit on a ground pad. We mounted three wall heads: living room, main bedroom, and home office. We ran the line sets, the drains, and a new circuit. The owners now heat and cool each room on its own. Typical price for a job like this: $11,200. The full write-up is on our results page. Homeowners: David and Amy — Berthoud, CO.
What mini-split work covers
- Single-zone installs: one outdoor unit, one indoor head. The classic fix for a bonus room, garage shop, primary suite, or home office.
- Multi-zone installs: one outdoor unit feeding two to five indoor heads. Each head has its own remote and temperature. Right for additions and whole smaller homes.
- Indoor unit options: wall-mounted heads are the standard. But ceiling cassettes and low wall units exist for rooms where a wall head looks wrong or will not fit.
- Repair and service: refrigerant leaks at flare fittings. Condensate drain clogs, the number one mini-split service call. Control board and sensor faults. And deep cleaning of the indoor blower wheel, which grows mold film in humid summer use.
- Cold-climate models: for Loveland winters, we specify units rated to keep heating in subzero weather, not mild-climate equipment that quits at 30 degrees.
Signs a mini-split is the right answer
- One or two rooms are always too hot or too cold while the rest of the house is fine.
- You are adding living space: an addition, a finished basement, a converted garage.
- Your home has no ductwork, or the ductwork cannot be extended without major demolition.
- A boiler or radiant system heats the house but there is no cooling at all.
- Family members want different temperatures in different rooms and everyone is tired of the thermostat war.
- Your swamp cooler handles the main house but leaves a west-facing room miserable.
Mini-Split Systems in Loveland homes
Loveland has plenty of the housing this equipment suits. The older homes near downtown and around Lake Loveland were built for furnaces or boilers. Some have no ducts at all. A mini-split adds real air conditioning without carving the house apart for ductwork. A few streets over, 1970s additions and converted garages hang off the back of ranches. No vents were ever run to them.
Out toward Berthoud and Carter Lake, acreage properties often have a detached shop, studio, or barn apartment. Each needs its own heat and cooling. Running ductwork out there makes no sense. A single-zone mini-split does the whole job off one outdoor unit.
Altitude is part of the spec here too. We are at just under 5,000 feet. Cold air pools in the Thompson Valley on still winter nights. So we size for the actual low temperatures your part of town sees, rather than the brochure number. West-side homes near the foothills also get more wind exposure. That affects where the outdoor unit should sit, to keep defrost cycles short.
What affects the cost of a mini-split
Most Loveland homeowners pay between $4,500 and $7,500 for a single-zone installation and $9,000 to $18,000 for a multi-zone system covering several rooms. The drivers:
- Number of zones: each indoor head adds equipment and labor, though zones share one outdoor unit.
- Line length and routing: short, straight runs between the indoor and outdoor units cost less than long routes through attics and walls.
- Electrical: most installs need a new dedicated circuit, and older panels sometimes need capacity work.
- Cold-climate equipment: subzero-rated models cost more than standard units, and they are the right buy in this valley.
- Mounting and access: second-story heads, roof-mounted outdoor units, and concrete pads all add labor.
Related services
For whole-home ductless alternatives with a central unit, see Heat Pump Services. Adding cooling to a home that already has good ducts? AC Installation covers central systems. If the ducts are the problem itself, read Duct Repair & Replacement.
